Using electrical wire is just temporary and where you can an emergency situation where at least for a limited time you will get water. It is better to do this when the 24 hour plumber san diego services are not available. We use the electrical wire just to block the hole to prevent the leaking for some time. Actually, you can take some additional scrapings which will fit for the hole and add a couple couplings and a piece of pipe and solder them together. This is the right way to do it. But you may not have all these components so it is easier to follow the temporary method to prevent the leakage from the hole so that you will be able to get water supply at least for some amount of time.
So, the first thing you need to do is to turn of the water of the house. Clean the wire and the part of the pipe where it is broken using a sandpaper. This will make sure that there are no contaminants on the pipe. Then, you shall need to put some flux on the pipe. After doing that, you can wind the copper wire around it so that the whole hole is covered entirely and there is no gap left. Then you can start with process of soldering and add some additional flux to the pipe. Wait until the solder has cooled completely, then wipe off the remaining flux and examine your joint. If in doubt, do some soldering again until you are satisfied with the result. When you are ready to turn the water back on, make sure you have no leaks and you have fixed the blast pipe. This is not the right way to fix the problem, but if you do not have the components, you can get out of trouble and you will have to re-install the water in the building. The pipe will work fine until the 24 hour plumber san diego services arrive, then they will fix the pipe properly.
Comments